Skip to main content
Feb 18, 2015 12:34 PM UTC
Question

Re: Simulation status: Failed while calculating

Domen,

If you don't mind me asking, what software version do you use?

    6 replies

    Feb 18, 2015 1:55 PM UTC

    I was using Creo 2.0 M120. Now I have upgraded on M140.

    Feb 18, 2015 6:18 PM UTC

    I've seen this problem as far back was WF4 (Wildfire 4) and up to Creo Simulate 2.0, but so far, I have not seen this in Creo 3.0 I got to the point where I would just ignore it, because tech support could never explain it.

    Feb 19, 2015 6:49 AM UTC

    I have checked results in simulation that had status Failed and the one which had status Running. The results were almost identical. So I agree with you that the best thing is to just ignore the status.

    Nevertheless, the tech support should look into this. The problem arises somewhere in the begining of the simulation, when the mesh elements are made or the model is checked for material, constraints and loads.