Skip to main content
Jun 20, 2014 8:00 PM UTC
Question

Re: Simulating 3 plates bolted together

WF4 fastener tool is ONLY for two components, and if a preload is required, two runs are required to get the desired preload.

    2 replies

    Jun 30, 2014 6:27 PM UTC

    What is the best way to handle 3 plates? I could assume that 2 of the plates are bonded together, but in the current model I need the 3 plates to be independent.

    Jun 30, 2014 8:09 PM UTC

    Hello, TractorGuy,

    Have you looked at the following link as well as those mentioned in the discussion.

    Cordially.

    Denis.

    http://communities.ptc.com/message/199770#199770