Skip to main content
Nov 9, 2016 1:35 PM UTC
Question

Re: Simulate fastener questions...CSV columns and edge references.

I think that would be a correct assumption.  Creo Simulate does not have functionality for counter-sink fasteners, and that's why I submitted a Product Idea to add it.  SolidWorks has it, so the image in the attached link is a screenshot from SolidWorks.

https://www.ptcusercommunity.com/ideas/3783

    1 reply

    Nov 10, 2016 3:46 PM UTC

    Thank you for your help. I have run some simple test cases and verified the small compressive forces that can be seen in the fasteners.

    It would be nice if PTC would allow for counter sunk geometry.  We don't look at them that often but occasionally there are times when a countersunk fastener is necessary even if it is not ideal for the loads acting on it, as was in one of my load cases for my current model.

    Again thank you for your time!