Skip to main content
May 1, 2017 7:01 PM UTC
Question

Re: should you use mirror in creo?

If your company will issue reprimands for using the mirror feature, and if it's a written internal policy, then I would not use it.  It's hard to believe a company would lower itself to such a standard as that.  The mirror tool is a great feature to have, especially for manufacturing right-hand (RH) and left-hand (LH) aircraft components.  Many times I have received a LH component, the RH needs to be manufactured.  You bet I'm going to use the mirror tool, instead of trying to re-create all that geometry.

If you're very proficient in mirroring, perhaps you could make a presentation on some of the models and show a cost-savings to management.  Maybe they will allow mirroring, after all, they want to see savings ($$$$$).  Right?

    1 reply

    May 1, 2017 7:22 PM UTC

    Thank you, actually the company that I work for now lost them as a client because of us not allowing mirroring. You can kind of see this as a cost savings or a good source of revenue to maintain this customer if only we weren't so closed minded and listen to the customer needs.

    Thank you again for your input and I'll use this as a good argument as I know it will come up gain.