Skip to main content
Oct 14, 2014 6:07 PM UTC
Question

Re: Sheetmetal - Surface need to thicken

I would either make it all in sheetmetal to start with, or make it all in part mode as surfaces, thicken, then switch to sheetmetal mode.

    1 reply

    Oct 14, 2014 6:55 PM UTC

    When you say make it all in sheetmetal to start with. Are you saying to make the first flat surface and then add then vertial sides, then add on the flanges.

    I apologize - both surfaces and sheetmetal are weaknesses of mine.