Skip to main content
Oct 14, 2014 5:33 PM UTC
Question

Re: Sheetmetal - Surface need to thicken

Dale,

If the sheetmetal was made as a surface, then you can thicken it with the Thicken Command (Figure 1 below). If the sheetmetal was made as a solid, you cannot use the Thicken Command (Figure 2 below), but you just assign the thickness during geometry creation.

sheetmetal_thicken_01.jpg

Figure 1

sheetmetal_thicken_02.jpg

Figure 2

    1 reply

    Oct 14, 2014 5:35 PM UTC

    What about WF5 menus?

    Also the vertical walls on my part are tapered from front to back (not a perspective view). Does this change how it would convert to sheet metal?

    Would I be better off making the large flat surfaces and then adding the side walls and flanges later?