Skip to main content
Mar 31, 2015 11:16 AM UTC
Question

Re: Regeneration problem in Creo Simulate 2.0

What are you showing for Mass Properties (as shown below)?

mass_properties.jpg

    3 replies

    Apr 1, 2015 11:53 AM UTC

    Hi, I have the following window:

    Untitled.png

    Apr 1, 2015 12:26 PM UTC

    Hello, Tommaso,

    I also met this problem on Creo 2 and 3, I'm the same way in the config.pro and it does not change,

    The room is in "green" before returning to Simulate and goes "yellow".

    I think it must come from a construction of the piece that is not perfect.

    I do not know when the room is "yellow" if the calculation Simulate are absolutely right.

    Best Regards.

    Denis.

    Apr 1, 2015 1:59 PM UTC

    Hallo Denis,

    thank you. You mean that if the light is yellow the calculations could be imprecise? if yes, therefore that would be a (very) bad surprise....even worse if it could not be changed so easily (or definitely not).

    Regards