Skip to main content
May 15, 2014 11:21 AM UTC
Question

Re: RAM and hyperelastic

Did you select "Yes" for interactive diagnostic before running? If so, you can share the diagnostics file without sharing the model, and that may give us some insight. See the below images for clarfication.

diagnostics_01.jpg

diagnostics_02.jpg

    6 replies

    May 15, 2014 12:33 PM UTC

    Hi Steven,

    I always say yes to diagnostics (I'm never really sure why a user wouldn't want them).

    Will dig them out later when I open call with TS as suggested by Gunter.

    Thanks

    Charles

    May 15, 2014 4:25 PM UTC

    Steven,

    A couple of screen shots. Diagnostics not helpful.

    When I started the study I had about 170Gb of free disk.

    I don't think this info helps much.

    Thanks

    Charles

    diagnostics.jpgsummary.jpg

    May 15, 2014 5:18 PM UTC

    Charles,

    How much free ram do you have without Pro/E running (48gb)?

    What is your SOLRAM setting set to?

    How much physical ram do you have installed on the machine?

    What's your virtual Memory Settings set to?

    When you mesh how many elements do you get?

    What the matrix size?

    What autogem mesh controls / refinement do you have assigned to the analysis?

    The above questions might shed some light,

    Don Anderson

    May 15, 2014 7:33 PM UTC

    Don,

    The rpt,stt and pas files attached.

    very modest matrix size.

    You can see that memory usage jumps from 0.5Gb to 21.3Gb at time step 0 of 200 remains there until about timestep 18 of pass 1..

    After this is takes a slice of additional memory each timestep until it runs out of space.

    The computer is configured to effectively have limitless (until disk is full) swap. I wasn't expecting it to use all of it.

    I am intrigued by this bit of the stt file ...

    Combining tri elements to form quad elements ...

    Adding 13585 solid elements to model ...

    Adding 31963 shell elements to model ...

    Displaying Elements ...

    because I don't have any shell elements !

    Thanks

    Charles

    .