Skip to main content
Dec 5, 2013 7:48 PM UTC
Question

Re: PTC Creo Simulate License Problem

Alexandra,

Is this the first occurance since installing Creo Simulate?

    2 replies

    Dec 6, 2013 12:45 AM UTC

    No this is not the first time since installing Creo Simulate

    Thank you for replying so quickly!

    Dec 6, 2013 1:47 AM UTC

    I used to get this type of problem, and I would have to restart the sever under lmtools.

    Search for your lmtool, probably in your flexnet folder. When you launch it, it should look like this:

    lmtool_1.JPG

    Go to the Server Status tab and perform an Enquiry to see if you have an active license:

    lmtool_2.JPG

    If your license is ok, go to the Start/Stop/Reread tab and stop the server, reread the license and start the server. If your server restarts, then try launching Creo Simulate.

    My server would stop on me, and that's what I had to do, just reread the license. Maybe this will solve your problem. It's just one approach. I can check the instructions when I get back in my office tomorrow.