Skip to main content
Feb 5, 2014 12:28 PM UTC
Question

Re: Problems with Singularities; New to Simulate

Hi Mark,

I know this "problem" has been put to rest, but I just wanted to show you that the Excluded Elements does really work, even on a single component. I took your model and created a Volume Region on one end of the beam. The excluded function excludes thoses elements from measure, not from the legend. I know, that's odd, but that's the way it works. You can see in Figures 3 and 4 below that the max prin is 1469 psi, not 1927 psi as shown in the legend. So when it comes to measures, the elements are ignored on the end of the beam.

exclude_elements_i.jpg

Figure 1: Volume Region on Beam End

exclude_elements_ii.jpg

Figure 2: Location of Max Prin in Beam (1927 psi)

exclude_elements_iii.jpg

Figure 3: Max Prin the run Summary (1469 psi)

exclude_elements_iv.jpg

Figure 4: Convergence on Max Prin (1469 psi)