Skip to main content
Jan 7, 2014 6:59 PM UTC
Question

Re: Problems with Singularities; New to Simulate

Your model generates 9096 elements because of the AutoGEM setting control where the max element size was set to equal to 2.

mesh_9060.jpg

Figure 1: AutoGEM Settings Max Element Size = 2

The default settings generate only 780 elements.

mesh_780.jpg

Figure 2: Default Settings

Try running your model with the default settings and compare the stress in the region of interest and see if it isn't about the same.

Creo Simulate is based on the p-version of the finite element method, in which the fidelity of the finite element model is increased by raising the polynomial orders of the finite element basis functions. This approach is in contrast to traditional h-version finite element programs, in which the fidelity of the model is increased by adding more elements.