Skip to main content
Sep 4, 2014 12:55 PM UTC
Question

Re: Old Chain Drive modelling

Could you post some pictures of the single and double chain drives?

    35 replies

    Sep 4, 2014 3:38 PM UTC

    I would love to but I haven't been able to create it yet, the sprockets should be easy its the chain that terrifies me. The single chain is as on a bicycle, the double one is a 1:1 on the reverse pinions from the main shaft, two chains running in parallel on a double sprocket.

    Sep 4, 2014 4:21 PM UTC

    This is an excellent tutorial on how to make the chain dynamic along a path.

    https://www.youtube.com/watch?v=-R9myIG5XjA

    Sep 20, 2014 11:33 AM UTC

    reverse_chain.jpg

    As you can see I cannot seem to get the assembly of the open links correct. I have followed the video suggested by Antonius which, up to point, very helpful but there is a gap in the dialogue at the and it fails to instruct how to assemble the open link so that it follows the closed one. Any suggestions would be helpful.

    Sep 20, 2014 3:18 PM UTC

    The video shows that is uses a "follower" set of points to keep the chain on the track. It looks like only one end of the open links constrained.

    Sep 20, 2014 4:26 PM UTC

    There is CSYS assembling the closed link and another assembling the open one. How do I use a 'follower' set, if I even knew what it was. it would help.

    There is a pattern of 27 X 2 datum points with the CSYS located on the first of the pair and the Y axis oriented to the second point then patterned reference the datum points. The video does not show how to locate the second link. Do I need to create a second set of datum and CSYS?