Skip to main content
May 21, 2015 8:06 PM UTC
Question

Re: More than 32 Gbyte memory

‌Erik,

I submitted a Product Idea over two years ago to increase the amount of RAM in Creo Simulate. Mark Fisher finally came back with a response, but when I questioned his response, he has yet to answer. I made the argument that increasing RAM was better than not increasing it at all. Please read that last two comments in the attached link.

https://www.ptcusercommunity.com/ideas/2424

    1 reply

    May 22, 2015 10:52 AM UTC

    Hi Steven,

    I wasn't (haven't been) aware of this 16 Gb  limit, I'm quite sure I already used up to 32 Gb, and seen crashes when the requirement was higher than that.

    I do not touch the memory allocation setting. At the default setting, Creo will happily run up to 32Gb, given a large enough model. Modal analysis on big models tend to do that, They show a peak memory usage, shortly between the last "solving equitions" and the "calcualting disp and stress results". I've seen jobs crash in thet stage (after convergence was completed. The job ran for the largest part but will not produce the results. I think I had success with lowering the memory allocation setting in one of those cases. I think it helped, but can not be sure this was not a co-incidence.

    For the rest: I fully suppoprt your view on the matter. Not finishing an analysis is 100% loss of performance. I do realise that we will always run in to limits, you could say enough is enough, but the software performs so well up to that limit, why not extend it to possibilities that were not there before?

    Erik