Skip to main content
Dec 1, 2014 12:40 PM UTC
Question

Re: Modeling an ancient sail ship

I assume that each rib profile (or bulkhead) may have it's own contour, but there may be several stations in the middle of the ship with the same contour.

I helped someone in the past with making the hull of a ship, but the drawing had all the necessary data points to make the curves (made my job easier), so there was no need to scan the drawing.

When you say "scanned rib profile", are you talking about scanning the drawing or sections of the drawing with a paper scanner? You may have to scan different profiles to obtain the entire curvature of the hull.

The example below is where I added an image to a datum plane, then traced the required features to make the body.

add_image.jpg