Skip to main content
Jan 27, 2014 1:22 PM UTC
Question

Re: Modeling a wing help?

This is a nice model, and I like the way you used the intersect function to give the wing an upward twist. I think what Jun wants is a continuous rounded leading edge until it tapers down to a rounded "point" (instead of having a flat end...see images below). This will require a bit more work to implement, and it's something I would like to see for myself. I don't know if this can be made with just a parallel sweep.

wing_tip.jpg

wing_tip_ii.jpg

    1 reply

    Jan 27, 2014 8:52 PM UTC

    Steve, this scenario can be closed (and sharp) at the end. I suspect it is a poor airfoil design in general, but from a modeling perspective, it can add a nice touch to esthetics.

    I changed the trajpar range in the section's relations from .8 to 0 (it allows a zero radius arc surprisingly) and I joined the ends of the two sketches. There are many ways you can control the leading edge radius including evalgraph is a specific shape is desired. The key to making this one work is the constant normal direction of the sweep. This endures the profile to the airflow is always normal across the front profile.

    wing_sharp_tip.PNG

    The model is actually quite robust. You can get quite a few shapes out of it. If you change the trajpar in the section relation, you can also vary the leading edge with a squared function or even a sine function on the "taper". You just need a value that returns a range from .8 to 0 from an input value of 0 to 1.