Skip to main content
Nov 3, 2014 1:04 PM UTC
Question

Re: Meshing BOM, Mesh Controls

The purpose of having Idealizations in Creo Simulate is to reduce run times. By adding Idealizations in Creo Simulate, you have increased the amount of mass from 1.566 kg to 4.682 kg. What was the purpose in comparing the mass in Creo Parametric vs Creo Simulate as shown below?

modal_mass_01.jpg

modal_mass_02.jpg

    1 reply

    Nov 3, 2014 1:22 PM UTC

    Yes.

    Sometimes simulation models are created exclusively using surface modeling, therefore model consist only surfaces and curves - which do not create any mass when you are investigating the situation in Creo Parametric.

    When one creates shells based on surfaces and beams based on curves, some mass starts to appear to model. Needless to say this is true for mixed models (models with solids, shells and beams) as well.

    The point/problem is: one cant get the true simulation model mass nowhere but on calculation log. Sometimes we made crude mistakes by stating wrong density, thickness etc to our simplifications. Therefore it would be nice to get a report for model mass and element distribution like suggested in product idea.