Skip to main content
May 13, 2015 6:56 PM UTC
Question

Re: Mesh Question

sjohnstone,

I ran the studies again with MPA at 1% convergence. The previous studies were MPA at 5%. The new 2D runs are:

1. Default autoGEM (23 elements)

2. AutoGEM control 1 inch max element size (110 elements)

3. AutoGEM control .25 inch max element size (1334 elements)

I saved all the results under one window, as shown below (easier to view). There is a 6.9% difference between the max stress in the first run and the last run for the hole, and yes, they all converged to within 1%. The convergence can also influence the solution. You cannot plot a convergence curve with SPA (Single Pass Adaptive).

3_runs_vm.JPG


    1 reply

    May 14, 2015 8:09 AM UTC

    Thanks very much for your advice and help with this, it is much appreciated! I now have a much greater understanding of this.

    I am currently in the process of creating my complex assembly so will put this advice into practice when I start the analysis.