Skip to main content
Apr 9, 2014 4:29 PM UTC
Question

Re: Making a mirror part

Giulio,

You can create a mirror component in assembly mode, but after examining your model, you have some features that cannot be mirrored.

The idea is to open the model in assembly mode as shown in Figure 1 and create component by mirror.

mirror_1.JPG

Figure 1

In the next step, you will see the mirror options, as shown in Figure 2.

mirror_2.JPG

Figure 2

As you can see in the upper left-hand corner of Figure 3, "Can not mirror some features of this part" is displayed. There's nothing wrong with the software. I think you have some very complex features that WF5 doesn't want to mirror. I even tried this in Creo Parametric 2.0 M100, same problem.

mirror_3.JPG

Figure 3

Sorry, I wasn't able to mirror this with features.