Skip to main content
Aug 9, 2016 2:20 PM UTC
Question

Re: Is there a way to set a default model for drawing sheet and format placement.

Could you elaborate on this?  Can you provide some screenshots?

    2 replies

    Aug 9, 2016 3:28 PM UTC

    In a multi model, multiple sheet drawing it appears that

    Creo takes the active model during each sheet creation and
    makes that model the default for the sheet. I have some drawings that the
    creation of these sheets was something other than what I need now. I would like to
    change this to the proper model and file it so in the future when I switch to
    that sheet it is referencing the model I intend it to be  for placement of the format. It becomes a
    problem specifically when placing a BOM format using a table.

    There are 3 Screen shots of the information at the bottom of
    the drawings in them.

    The first sheet references the Assembly, Just switching
    sheets 2and 3 reference a part.

    I would like a ll sheets to reference the assembly in this case.

    Aug 9, 2016 3:45 PM UTC

    You can't set a default, you just have to ensure that when you add the next sheet, the active model is the one you want to drive your format.

    You can "fix" an existing format by setting the active model to the one you want to drive the format and then replace the format making sure to remove the tables.

    You can also edit the existing format by changing the session ID on the end of the parameter to the session ID of the desired driving model.