Re: incorrect von mises and max principal of simple lifting lug static analysis
Hi Robin,
It's not uncommon to see "elements not converged" in the run summary because of the way the model was setup. To eliminate this, one needs to include predefined measures in the regions of interest. Plot convergence on the regions of interest, not the whole model. When you exclude elements, this only excludes from measure in the run summary and not the fringe plot legend. I have not look at your model, but if I get time today, I will, and show you an example of stress convergence plotting for the hole and the bend. I think you stated these are the regions of interest. Also, what is the mating geometry that assists in lifting the lug? For example, is it a large pin? Or a hook, etc.?
