Skip to main content
Feb 17, 2017 7:43 PM UTC
Question

Re: How to wrap a "Fill" (2D) surface over a cylinder?

Antonius,

I think this is what you are referring too in the below image.  The Sketcher CSYS will be grayed-out if there is no csys in the sketch for wrapped curves.  Only the Center option can be selected.  I had five wrapped curves, and when I first attempted this, I was using the Center option, but my curves were not aligning properly.  So I had to places a csys in sketcher for each wrapped curve.

wrapped_curve.jpg

    1 reply

    Feb 17, 2017 10:48 PM UTC

    Correct.  Thanks for clarifying, Steven.