Skip to main content
Dec 30, 2013 8:19 PM UTC
Question

Re: How to select the whole surface of an hole?

Hi Giuseppe,

First, upload an image of your intersecting holes, and point out the subject intersecting curves that require geometry creation.

You have two intersecting holes that are normal to each other with different diameters. I assume that you made the chamfer on the smaller bore, that intersects the larger bore, and now you want to put a round feature on top of the chamfer?

    1 reply

    Dec 30, 2013 9:24 PM UTC

    Hi Steven,

    i am so sorry for having opened a useless thread, because i have just tried again to do what i wanted to, with succes this time.

    Anyway yes, it was exactly that what i meant. I managed to get a full rounded fillet, but it went only trough half portion of the chamfer's edges. I thought it was due to the fact that when when i selected the cilindrical surfaces of the holes, actually, only half part of them became highlighted.

    But now i have no longer this problem, and yet, i didn't change anything in my procedure.

    I am sorry.