Skip to main content
Nov 27, 2013 6:08 PM UTC
Question

Re: how to open creo 2.0 file in wildfire 4.0?

Doug,

In GCRI link, there are some notes at the bottom of the page, and one of the notes states:

"GCRI support is limited to the previous two releases, except in Wildfire 3.0 which is limited to the previous release."

I'm using creo 2.0. Does this mean that I can't open files previous to WF5? Counting backwards from creo 2: creo 1, then WF5, that's the previous two releases. If this is what the note means, then I couldn't open .prt files created in creo 2 in WF4.

What are your thoughts on this?

Thanks for posting the GCRI info.

    3 replies

    Nov 27, 2013 6:14 PM UTC

    They are only "supporting" or guaranteeing it can be opened in the previous 2 releases. It may work on older releases. I haven't personally tried it but this is my interpretation of the statement. I think they make a similar statement on forward compatibility also, just limiting the guarantee of compatibility doesn't mean it won't work.

    Steve

    Nov 28, 2013 2:36 PM UTC

    Steve,

    Thanks for the reply. I will attempt this next week - open a creo 2 file in wf4 using GCRI.

    3-Newcomer
    Dec 2, 2013 2:38 PM UTC

    Sorry, missed this over the holiday weekend.

    The plug in is to allow older releases to open newer files. Newer releases will always be able to open older files, theoretically without limit. I've opened 15 year old files from release 16 or 17 in Creo 2 without issue.

    For GCRI, I thought it went back 3 releases, I guess I was wrong. UIt seems that you may only be able to open files up to Creo 1 in WF4. Creo 2 files should be able to be opened back to WF5. As Stephen said, it may work in WF4 anyway, but if it doesn't PTC isn't going to help you make it work.

    Good luck,