Skip to main content
Jan 13, 2016 1:53 PM UTC
Question

Re: HOW TO CONDUCT LIFTING LUG ANALYSIS IN PRO-MECHANICA?

If you're performing a lug analysis, you could use the hand calculation method that I've attached.

    8 replies

    Jan 13, 2016 3:16 PM UTC

    A word of caution here: the document of Steven is used in aerospace and while it is very useful, it is (if I recall correctly) only valid for closely fitting pin-lug connections without out-of-plane loading conditions (as is common in aerospace, but much less so in other areas).

    If you are going to lift the lug with some sort of hook, you will need to use different methods.

    But still, the document shows different failure modes, so it gives a good direction on things you should check in your lug design.

    Jan 14, 2016 4:16 AM UTC

    Helloo Patric,

    Yes, my assembly is going to be lifted with hooks, do you have any literature for calculations for  such a case.

    Kudos,

    Prasad

    Jan 14, 2016 7:24 AM UTC

    I only know of ASME-BTH1 and EN13155, but I cannot post them here due to copyright reasons.

    (Isn't it remarkable how organisations expect you to use their standard and then put copyright on them?)

    Which methods do you currently use?

    Jan 14, 2016 4:12 AM UTC

    Hello steven,

    Thanks for your reply i have used diffrent methodology, but sure will check as per your given literature,

    As mentioned earlier, whole assembly weight could go up to 50MT where i need to design 4 Lugs capable lifting such a load.

    Kudos,

    Prasad

    Jan 14, 2016 8:33 AM UTC

    I have to ask... MT?  If using SI units I think that would be 'mega Tesla', but that would be a gigantic magnetic field...

    Jan 14, 2016 8:45 AM UTC

    No Mate,

    MT as in Metric Tonnes

    Jan 16, 2016 7:28 AM UTC

    Hey Steven,

    Will you please mention name of the book/literature from which the methodology you have provided.

    Regards,

    Prasad