Skip to main content
Nov 3, 2016 4:51 PM UTC
Question

Re: Help with Reducing Thickness in the Basement Structure (File Attached)

David,

Is this a real component?  I'm asking because it's so massive (70" tall, 79.76" OD, 67.5" ID, and 19841 lb).  This is supposed to go in a basement?  But to answer your question, in order to use the advanced fastener tool, you need two components.  In this case, the floor and the cast iron part.  The first thing that needs to be address is what is the floor made of?  If it's concrete, concrete is very poor in tension, but excellent in compression.

basement_1.jpg

    2 replies

    Nov 4, 2016 9:50 AM UTC

    Hi Steven!

    Thanks for the answer, finally someone opened the file and took a look!

    Yes, it is a real component, (the gearbox of a vertical roller mill which pulverizes coal for thermal power plants).

    I deleted the Details due to confidential issues. but the main structure remains the same.

    It is supposed to be directly to the floor (I don't have the exact Details of the floor)...´

    How could I affirm that it is excellent at compression with the program or results? I know it´s Logical, but maybe there ir some Special Feature from Creo Simulate... In fact that´s why it was made for, for vertical loads, I am just simulating (trying) the worst cases (almost impossible)

    Someone from the Office recommended me 2 Options:

    1) apply the preload (1097298 N) in each cylindrical surface where the 8 holes.

    2) creating a surface Region in each hole with the area of the screw´s head and apply the preload (1097298 N) there.

    Nov 4, 2016 12:14 PM UTC

    New info:

    The material of that ground is: S235JRG2

    It is a surface of 2350*2350 and 100 mm of thickness, and with 8 holes at the same Position as the other 8 holes.