Skip to main content
Feb 11, 2014 10:51 PM UTC
Question

Re: Helical Sweeps

Hi Sam,

What you're asking can be done, but I don't know if making the first helical sweep (the one attached in your question) should be with Creo's out-of-the-box helical function. What you will need to make another coil around the existing coil is to first have a trajpar that will follow the center of the first coil. Imagine a blue curve following the center of the first coil. This can be made with a curve through points, as you will have to establish the points. Once you have the first curve and a helical sweep made from that curve, you can then make a nonlinear helical sweep around your first coil. The nonlinear method is demonstrated in the attached video:

http://www.youtube.com/watch?v=jXYoUdE6eSg

This other video is attached for general knowledge of helical sweeps. This video shows how to bend a helical sweep with a curve, but it shows it only in one plane. This example is towards the end of the video.

http://www.youtube.com/watch?v=V4R8kQh3bos