Skip to main content
Jan 12, 2016 12:54 PM UTC
Question

Re: flat pattern complex geometry

Redro,

In order to make the attached model into a flat pattern, the model must have uniform thickness.  I checked the thickness of the .stp file, and there are different thicknesses, even though slightly different.  I tried to convert this to a flat pattern in sheet metal mode, but I was not able too, as shown below.

flat_pattern.jpg


    6 replies

    Jan 12, 2016 2:12 PM UTC

    probable this .stp is maked in surfaces and this is the reason for model have a different areas with different thickness

    but what i do for correct this ?

    Jan 12, 2016 11:05 PM UTC

    Try a copy geometry of the top surface, give it a uniform thickness with the thicken command, and then try to flatten it.