Skip to main content
May 26, 2015 5:19 PM UTC
Question

Re: Fasteners references edges definition error

Tommaso,


The edges are parallel, but the component surfaces are not perpendicular to the hole.  This requirement must be met in order to use the fastener.  Please see attached conditions.

    1 reply

    May 27, 2015 9:37 AM UTC

    Hi Steven,

    thanks for your suggestion, the flat surface within the countersink seems to be a good  alternative indeed.

    I thought also about creating two reference points in the center of the the edges and then define a bolt between them (that would be quite similar to Mats' suggestion with rigid links).

    bye