Skip to main content
May 25, 2015 7:04 PM UTC
Question

Re: Fasteners references edges definition error

‌When I have a countersink, I have some flat surface at the connecting reference, and that's how I deal with countersinks.

    1 reply

    May 26, 2015 10:28 AM UTC

    do you mean the top flat surface just above the countersink? (see light green highlighted surface below in the screenshot):

    1.png

    in this case the definition of the screw in simulate wouldn't be correct as the active part of the screw starts from the beginning of the cylinder.

    the problem in my case anyway is that this surface in my component isn't flat because the countersink is located on a curved surface.

    thanks

    bye