Skip to main content
May 15, 2014 6:41 PM UTC
Question

Re: Fastener with preload for 3 components

Shaun beat me to the question...I was going to ask for some images too. Can you provide us with some images?

    9 replies

    May 15, 2014 7:36 PM UTC

    Unfortunately the design is proprietary, so I can't upload the file or give too many details. I have attached a basic sketch however. (excuse my poor art skills ha!)

    I thought I had solved my issue, but I'm not quite there yet. As I said before, I've got the fasteners set up with beams and links. Through the use of the temp. load I've been able to get my preloads as well.

    I'm using contact interfaces between all parts. The main bracket is constrained properly, but I'm having trouble constraining the caps properly. I'm currently trying to use some very light springs to constrain one of the caps to the bracket. When I run the simulation with just the preload and no other forces, the stresses come out as expected and the models deform as expected. I then added in the pressure loads which act on the caps and the bracket. This is where things go badly and the parts deform and separate unexpectedly.

    Hopefully this helps explain a bit better

    May 15, 2014 7:51 PM UTC

    With regards to just one of the beams representing a fastener, you have a rigid link between a surface on the cap and end of the beam, and a rigid link between a surface on the bracket and the other end of the beam, correct?

    How exactly do the parts deform and separate? Is the pressure load applied on the inner surface of the caps and bracket (like a bearing load)?

    EDIT: I think I see what is happening here. Your beams (aka fasteners) don't directly connect to the bracket, correct?

    May 15, 2014 8:00 PM UTC

    I agree with you Shaun,