Skip to main content
Jun 18, 2014 2:00 AM UTC
Question

Re: Fastener "separation stress" measure

If you are going to use a preloaded fastener, you must make two runs with just the fasteners. After you obtain the desired preload, then you make a final run with the external loads. What is the desired preload for the fasteners?

    2 replies

    Jun 23, 2014 5:57 PM UTC

    Hi all,

    Here is additional detail on the preload force for fasteners.

    In CREO 2, when a preload is specified in the definition of fasteners, its value is taken as the load that the fastener applies on the un-deformed geometry of the model. It is applied with the specified value together with all other applied boundary conditions. As the model deforms, the compressive force of the fastener on the structure relaxes. The resulting (actual) preload is in general substantially lower than the specified value and is reported as the fastener Name_axial_force measure in the Summary file.


    Typically, users wants to apply the preload that the fastener will exert on the structure in its deformed configuration – after the fasteners have been tightened, but before the external load has been applied. Today, in order to simulate that, the user has to apply a preload value to the fasteners and run an initial analysis. Based on the reported fastenerName_axial_force measures, the user would then scale the preload values in the fastener definitions and rerun the analysis with the new preloads and the applied loads. The second time, the actual preloads will be approximately equal to the desired preload.

    With the release of PTC Creo Simulate 3.0, we have automated this process. Users would apply the preload force in the fastener dialog and if they want it applied to the deformed shape, they would select a new checkbox called 'Account for Stiffness'. When an analysis is run, the solver will run the analysis twice in the single process. The initial run will determine the the reduced value and auto scale the preload to match the entered value specified by the user in the dialog. The results will show the impact on the deformed model.

    Hope that helps,

    Mark

    Jun 24, 2014 2:32 PM UTC

    Did you look my assembly in the zip file?

    Can you say me why the screws that should not be loaded from the external force have an axial force higher of preload force?