Skip to main content
May 20, 2014 6:11 PM UTC
Question

Re: Fastener "separation stress" measure

You have a zip file within a zip file. Please save over again and upload. I cannot check your run summary for positive separation stress values. If you have positive separation stress values, read the following note:

A positive value for the separation stress measure indicates that the distributed separation spring has the undesired consequence of forcing the two contacting areas to remain in contact with each other, even though they should naturally separate. To fix this issue clear the Fix Separation check box and create a contact interface between the two parts that are connected by the fastener.

    1 reply

    May 20, 2014 9:54 PM UTC

    I've just open the file on my house's pc (I uploaded it at office) and It works.

    I don't understand why it has created two files, one inside the other

    I've created a 7z (7zip) file, but when it was uploaded it became "*7z.zip" file....

    But if you extract all the content of the second zip file into a new folder, you'll have all that you need for visualizing the entire assembly.
    The only things that I've not uploaded are the files that proE creates during the simulation because are too much big; but the simulations results there are.

    Now I retry with winzip.