Skip to main content
Apr 20, 2015 8:26 PM UTC
Question

Re: Expanding the middle part of a pipe

Patric,

Welcome to the forum. You want to be able to add material to the pipe while keeping the holes the right distance from the ends of the pipe? The best way to do this is with relations. I've attached some images to help facilitate visualization. When you create a double sided blind pipe, go to the Feature Information for that extrusion, and you will see some parameters, such as d0, d1, etc. When you make the holes at the end of a pipe, make the dimension for that hole from the datum plan with relations. The example I used is I want the holes to always be 0.5 inch from the ends of the pipe. When you place the pins in the holes in the assembly, you will have to make sure the pins are constrained with the hole so when you change the pipe length, the pins will move with the holes.

pipe_extrude.JPG

pipe_extrude_4.JPG

pipe_extrude_1.JPG

pipe_extrude_2.JPG


pipe_extrude_3.JPG

pipe_extrude_5.JPG

    5 replies

    Apr 20, 2015 10:07 PM UTC

    Steven,

    Wow, thank you very much for taking the trouble to give such a comprehensive answer. This was exactly what I was looking for. Based on your information I did some more research because your screen lookes a bit different from mine. I believe the relations feature is only available in the paid version, not in the free Modeling Express version I use. There is a thread suggesting this, if I am reading it right (I am German) Does Creo Elements Direct Modeling Express 6.0 support assembly constraints?. At the end of the day, it is only understandable PTC are disabling some functions in the free version. I guess I have to start again with a longer pipe.

    Anyway, thank you very much!

    Apr 21, 2015 3:02 AM UTC

    Modeling Express is an entirely different application. Check the Creo Elements/Direct community. Steve's answers are for Creo/Parametric. Elements Direct and Modeling Express used to be CoCreate from HP, but was spun off and finally bought by PTC.

    3-Newcomer
    Apr 21, 2015 2:53 PM UTC

    Ryan Kelley‌ - This is why we need better navigation and separate communities for each software. I'm not even sure how David found the Creo Elements/Direct community (I can't find it from the home page), nor am I sure that it's the right community to get Patric the help he needs with Creo Elements Direct Modeling Express.