Skip to main content
Mar 27, 2014 3:14 PM UTC
Question

Re: Exclusion of a component

Hi Giulio,

1. Your model would not mesh in Creo Simulate 2.0 (code M080) as shown below. I'm not saying it would not mesh in earlier versions.

2. When running fasteners with a preload, you will have to make two runs in order to get the right fastener load. If you want some information on this, I can furnish it.

exclude_components_iii.jpg

    2 replies

    Mar 27, 2014 3:26 PM UTC

    Very nice; I accept gladly any documentation.

    When I have a multi-body assembly with fasteners I need to specify a contact region "contact"? But, it does not would have to make this the program automatically simply putting a fastener?

    Mar 27, 2014 9:59 PM UTC

    I played around with his model; looks like it was an issue with the fastener "M8_2"; the model meshed after re-defining it.