Skip to main content
Mar 26, 2014 10:41 PM UTC
Question

Re: Exclusion of a component

If you isolate a component, it will ONLY exclude it from measure in the run summary file and not the legend level. And you must remember to check the exclude elements in the run study window. The image you're showing is only the AutoGEM setting. Also, if you're running a multi-body contact analysis, you may want to keep it, depending if it's in contact with another member of primary interest. Do you have an image that can be uploaded?

    1 reply

    Mar 27, 2014 11:53 AM UTC

    I have this assembly, already simplified for the FEM analysis.
    It is an equipment testing.
    I need to see the displacement (especially the vertical one) ander the mass load of the components.
    Some components are suppressed and replaced directly with their forces.

    The component PB1130426 serves only to transmit a force and it is the anchorage for two screws but I'm not interested into stress and/or displacements of it, so I would to exclude it from the analysis.