Skip to main content
Feb 8, 2014 1:39 AM UTC
Question

Re: Drawing a Dual Component Cartridge

Can you upload a picture of the component?

    2 replies

    Feb 8, 2014 2:31 PM UTC
    Feb 11, 2014 1:28 PM UTC

    Hi Peixiong,

    I currently don't have documented instructions, but after viewing your part, you will have to make an assembly. For the main component (two tubes), I would model only half and then mirror it, as this will save you some time. Make sure you have a plane for symmety to mirror about.

    dual_component_cart.jpg