Skip to main content
Feb 5, 2014 11:46 AM UTC
Question

Re: Cylinder analysis in CREO 2.0

Hi Vinay,

If you're not concerned about the stresses in the threads, you could just apply a pressure distribution in the lower cavity using a 2D axisymmetric analysis while capping off the top of cylinder B.

    3 replies

    Feb 5, 2014 12:16 PM UTC

    HEllo Steve

    THanks for your reply.

    I am Not concerned about the stress in threads.

    HOwever what is happening is the internal pressure in part B causes deformation radially thereby loosing the thread connection between part A & B.

    Hence I would like to have both parts in study.

    Feb 5, 2014 12:39 PM UTC

    In that case, it appears you would have to split the model down the axis of rotation and create a 2D model with threads in contact.

    Feb 5, 2014 12:44 PM UTC

    Steve

    THanks for your reply.

    I Will try modeling the threads with contact.