Skip to main content
Jan 27, 2014 12:18 PM UTC
Question

Re: Creo Simulate Result Window template with legend values: bug?!

Also, can you upload your input file? This would be your model (.prt file ext).

    3 replies

    Jan 27, 2014 2:02 PM UTC

    Steven,

    The part is in the static upper beam folder: 4118012

    This issue is not part related, in my opinion. It happens when I create a template with the settings as shown in the picture below.

    screenshot+creo+simulate+result+window+template+creation.PNG

    Jan 27, 2014 3:07 PM UTC

    Laurens,

    I too have seen this issue with my templates. In your template does the names in the bottom of the window (not shown in the image above) change when you change analysis or does it keep the name of the orginal analysis that was used to create the template?

    Don Anderson

    Jan 27, 2014 4:13 PM UTC

    Don,

    To be honest, I never pay attention to the names at the bottom. It says: "Window1"-existing -existing and "Window2" existing- existing.

    It doesn't change, as far as I know. So the names should be the ones you entered in the beginning. When opening a result window from own template, you're not asked to change the window titles.

    In general I take snapshots and put them in a document. I don't include the names when selecting, because the descriptions on top speak for themsevles: Displacement Mag (WCS) and Stress von Mises (WCS)

    Laurens