Skip to main content
May 18, 2015 10:58 PM UTC
Question

Re: Creo 3.0 Simulate results "The selected window is empty as currently viewed." ??

‌I've never seen this problem before, so I will check it out when I get back to my office later this week. I know that doesn't help, but until I test it myself, I really don't know. There's View Max and View Model Max. If View Model Max is selected and you zoom in to far...you might get such a message.

    3 replies

    May 19, 2015 5:51 AM UTC

    Thank you for your reply.

    A little more info:

    • Model Max appears to be working perfectly, just as it has done in the previous Creo versions. I only experience the described regression for View Max, View Min, and Dynamic Query.
    • I experience the problem as being identical on both of the work stations I have access to. One is a single monitor setup, and one has two monitors.
    • The problem is not affected if Creo 3.0 is started in a remote desktop connection or while logged on physically at the workstation. One the same work stations the abovementioned features work perfectly with Creo 2.0.
    • I experience the problem for all models I have created with Creo 3.0 and for models created in Creo 2.0 and opened in Creo 3.0. Even a simple console beam created in Creo 3.0 shows the issue.
    • The problem appears unaffected by the settings I choose for the results window, e.g. continuous tone or not and with/without deformation.
    • All the models I work on are metric, in case that could be the reason...
    • The Creo version I am using is Creo 3.0 M020

    Please let me know if there is any additional information I can provide to help correct this issue.

    May 20, 2015 5:26 PM UTC

    Seems to be a regression from Creo 2.0:

    CS186923 : Using "View Max" in Creo Simulate results window shows information window "No maximum value could be determined. The selected window is empty as currently viewed." in Creo Simulate 3.0

    Issue is currently investigated by R&D

    Jun 1, 2015 6:30 AM UTC

    In the hope that it helps those trying to locate the problems with the results window in Creo 3.0: Every time I delete a query tag, the following error message pops up:

    PgiObjectHost.jpg

    In spite of the error message the query tag is deleted as requested.