Skip to main content
Aug 20, 2014 11:48 AM UTC
Question

Re: Creo 2 Preload vs Fastener

If you're using a solid bolt to connect two plates, you will also need contacts between the bolt and plate holes. I would recommend splitting the bolt shank surface to match the plate holes.

Also, Creo 3.0 does now account for fastener stiffness if you're using the advanced fastener tool. So the operator does not have to make two seperate runs. You have to check "Account for Stiffness" in the fastener definition window, as shown below.

preload_03.jpg