Skip to main content
Mar 25, 2014 10:10 PM UTC
Question

Re: CREO 2.0: Creating surface/volume regions in subcomponents of assembly

Once you add a surface region to a part, you don't have to keep adding it, because it's stored in the input file.

    2 replies

    Apr 28, 2014 8:54 PM UTC

    Hi Jack,

    A few more points on adding a surface region or volume region to an assembly.

    1) These features are added to a component not the assembly. Once you select the component, you can sketch your form and then choose the surface to apply the the surface region too or define the depth for the volume region.

    2) In the event you have an assembly cut created which intersects the component in which you are trying to create a surface or volume region on, you will be presented with the message you attached in the initial thread. Creo Simulate does not allow creating simulation feature such as surface regions or volume regions on a component that intersects with an assembly cut.

    Hope this helps.

    Thanks,

    Mark

    Feb 15, 2016 7:48 PM UTC

    Assembly cuts do seem to block this functionality - you have to delete them - you're blocked even if they're suppressed