Skip to main content
Dec 4, 2013 6:07 PM UTC
Question

Re: Creo 1.0 parametric: sphere problems

Basim,

It looks like you're trying to use the Extrude function (extruding a 3D solid), according to your model tree, but the tutorial does not. The tutorial uses the Sketch feature and Revolves that sketch around an axis. Go back and watch the video again:

Sketch feature, draws an arc and connects the arc with a vertical line.

Sketch in a center line for the revolve feature.

Select OK.

Select the Revolve function.

sphere_solid.jpg

    2 replies

    Dec 4, 2013 9:42 PM UTC

    Thanks a lot Steven,

    You were right. I was using 'extrude'.

    Well, when should we use 'extrude' and when prefer 'sketch' ?

    Another question! My concern lies primarily in drawing 3D mechanical models. And I am a beginner afore mentioned. So how should I proceed in learning creo and mastering it. Any practice exercises you recommend?

    Dec 5, 2013 1:01 PM UTC

    1. I think you are already aware of the free PTC videos at the learning exchange:

    http://learningexchange.ptc.com/

    2. There are a lot of free Creo videos on YouTube.

    3. Barry-Wehmiller International has free webinars, you will find some of them on YouTube also. You may send an email to jason.hardebeck@bwir.com

    and requested to be on distribution for their free webinars.

    http://www.bwir.com/

    http://www.bwir.com/products/community/weekly-technology-tips-webcasts