Skip to main content
Dec 16, 2014 12:24 PM UTC
Question

Re: convert units without any changes in drawings?

Manish,

For now, I'm going to assume you have an assembly in Pro|Engineer or Creo Parametric where the components have different units of measure.

I would recommend changing the entire assembly to the same units, and this will include all subcomponents, as shown below. You can check "Include Submodels", and this will change all the submodels in the model tree.

units_change_all.JPG

    1 reply

    Dec 16, 2014 5:46 PM UTC

    Is that new?