Skip to main content
Apr 23, 2015 11:39 AM UTC
Question

Re: Contact surface area error

Damian,

Go to the Diagnostics window and select File > Save As and save the file. Can you then upload the entire diagnostics file for us to look at? There's something wrong with the geometry, and if you will select on the identified errors, it should tell you the problem.

    2 replies

    Apr 23, 2015 3:04 PM UTC

    I attached the text file. I am going to run the tolerance report and make changes as needed. Any "rules of thumb" to set the tolerances to?

    Apr 23, 2015 4:26 PM UTC

    Attached is my most recent diagnostic. I am working on getting the tolerances closer but I do not know what it means about: curves having load but not part of any element, rotational components, and the integrated mode error checking. Any ideas would be much appreciated.