Skip to main content
May 20, 2014 5:14 PM UTC
Question

Re: bug in displacement?

Can you upload an image of your problem? Better yet, can you upload the model? What scale did you make your plot? Is it a multi-body contact analysis?

    6 replies

    May 20, 2014 5:49 PM UTC

    unfortunately I can't upload the model or expose any detail of what I'm doing exactly. this is a concept I am talking about. I have a beam which is constraint in red point and is resting over the v groove ring which I showed in detail how is the v ring look like in the sketch. but after I ask creO to show me the deflection, the beam gets into the ring! that means the ring is not a boundary for the beam.deflect.jpg

    May 20, 2014 6:38 PM UTC

    Based on your picture, I believe there should be a contact defined for each contacting surface. example the v groove should have a contact defined for each of the v groove surfaces (2 total).

    Don

    May 20, 2014 6:49 PM UTC

    Alright, Can you be more specific what do you mean by contact? I assume you saying that there should be some kind of constraint on the v surface which I think "Boudary" is what I need to use.