Skip to main content
Mar 25, 2014 3:56 PM UTC
Question

Re: bend unbend of hollow pipe

Kamlakar,

See if the below equation and images will work for you:

material_for_bend.JPG

Let's use a 3" radius, 90 degree bend and a 0.5" diameter tube with a wall thickness of 0.100". Using the above equation, you will need 4.725" of tubing just to make the bend. And let's say you want the two ends to continue 7" each. The total length of tubing will be (7+ 7+ 4.725)" = 18.725"

unbend_dimensions.jpg

Figure 1: Unbend Dimension

bend_model_dimension.jpg

Figure 2: Bend Dimensions

bend_curve_leg_length.jpg

Figure 3: Dimension of One End

bend_curve_length.jpg

Figure 4: Material Bend Length for Radius (4.712")

This is very close the the 4.725" computed witht the equation. Only 0.013" difference.

    5 replies

    Mar 25, 2014 5:25 PM UTC

    Great reference, Steven. Like the K-factor in sheetmetal but it is very close to the centerline for tubing. The thing about tubing is the deformation is much greater. I wonder if this holds true for hydroforming (?).

    Mar 25, 2014 5:32 PM UTC

    Unlike sheetmetal, tube forming results depend on the types of dies and mandrels used/available to prevent the tube from forming an oval or crushed section. Ideally formed there is no difference as stretching/compressing is only dependent on the distance from the neutral axis.

    In hydroforming one could have only stretch forming - this would push the neutral axis to the inside of the bend, possibly smaller than the inside radius. It would thin the outer wall much more than plain bending.

    Mar 25, 2014 5:48 PM UTC

    I guess in hydroforming, you would have to pre-nbend the tubing to some level. But the expansion in all directions would make sense.

    Mar 26, 2014 4:15 AM UTC

    Steven

    Thanks for your reply.

    I have all dimensions with me.I want to create one drawing with unbend and bend pipe.Model is also one.

    Right now I done it by simplified representation.

    My question is whether it is possible to create it by unbend,bend feathers.

    Picture1.png