Re: Beam/Truss analysis
Victor,
I think I've worked this problem before. It looks like a problem out of Dr. Toogood's book, but I'm out of the office this week. There is a dimensioning error in the problem. If you look at the two 2 meter vertical lengths (4 m total), it's not as long as one of the 4 m lengths below it. So I scaled it in Pro|Engineer, and it was around 1.5 m, been a long time since I worked it. But I think I put in all the datum points and used the beam tool with point-to-point connections. You can pick your own cross-section with the beam tool. Creo can do this, as this is a very simple problem to work.
