Skip to main content
Feb 16, 2017 3:20 PM UTC
Question

Re: Averaged Result values per individual mesh in Simulate?

Erick,

By default, Simulate averages the stresses in the elements, unlike Mechanica, where the operator had the option to view averaged or un-averaged stresses to check for continuity.  I currently don't know of a way to plot the stress on a single element, like you can in StressCheck.  But you can set up pre-defined areas for measure and plot convergence on those areas/regions of interest.  This will tell you if you have a singularity in the region of interest, because singularities do not converge.

If you are concerned about singularities near constraint edges, you may omit these elements from your measures that are produced in the run summary.  It may still show up in your legend, but not in the run summary.

Welcome to the forum.