Skip to main content
Sep 17, 2014 8:55 PM UTC
Question

Re: Aspect ratio of prismatic elements (wedges & bricks)

So you're just testing the AutoGEM controls and not tryring to recover any particular data of interest.

    3 replies

    Sep 17, 2014 9:18 PM UTC

    The assembly that I've posted was a part of a work. But in that case it wasn't important why autogem max aspect ratio control didn't work well, because I found anyway displacement and stress.

    But the question of "why it did not work on prismatic elements" remains and I would understand why.

    Sep 18, 2014 3:34 PM UTC

    Those regions served when I tried to use Mapped mesh control and I needed these for meshing around the holes