Skip to main content
Sep 17, 2014 8:00 PM UTC
Question

Re: Aspect ratio of prismatic elements (wedges & bricks)

You have a lot of AutoGEM controls that are influencing the automesher. You're making long thin brick elements with hard points and the prismatic control. This will control the mesh in these regions regardless of what you set the aspect ratio to be, which in this model is 8. A very low aspect ratio will slow your run times. PTC recommends keeping the aspect ratio at 30, the default. The advantage of using the adaptive p-method is you have the ability to have high aspect ratios.

There are a lot of exclusions too. This will only exclude from measure and not the fringe plot.

What exactly are you trying to recover in this model?

    1 reply

    Sep 17, 2014 8:46 PM UTC

    In the model I put the hard points because the wedge/bricks were very long in that area, like in the picture in the first post.

    Steven Dunker ha scritto:

    The advantage of using the adaptive p-method is you have the ability to have high aspect ratios.

    What you say is correct but I need to know how the program works.

    I've just do some simple test and it seem that, for "Prismatic elements".

    2.JPG(default)

    4.JPG5.JPG

    (maxaspect ratio 10)

    I think the aspect ratio is not reported in the direction of the "extrusion" (specified in the definition window).